Frigidaire FFRP152HT3 Uživatelský průvodce

SYSTEM CONFIGURATIONKEYPAD CONFIGURATIONKeypad ConfigurationYou can customize your unit additionally using the keypad configuration options.To enter K

4..unit5."fan speed"It is used for setting high, low or auto fan speed. The corresponding LED will be lit when selected.6. "timer"

7. Timer function(1) Timer ON: When the unit is off, timer ON can be set. Setting range is 0.5~24h. When timer ON time is reached, the system will ope

the181921 S 19control panel guardtwo Low fan Hi fanLH on page 17

20ncorrect212021 Frigidaire on-theyerror the can i23Table 5—STATUS LED Indicator Definitions1Indoor air temp sensor open/short8-segment display ‘F1’,

23o days (or sooner depending on application).Product failure due to improper care or lack of maintenance is not covered by warranty2425Product failur

16(Best to use compressed air.)

17LCDILCDIThere is a protective time delay (approx.3 minutes) on starting the compressor after a power outage (or restarting after it has been turned

2010 Electrolux Home Products, Inc. All rights reserved.18SAFETY PRECAUTIONSSAFETY PRECAUTIONS DANGER! Avoid Serious Injury or Death1. Do not attempt

MAJOR APPLIANCE LIMITED WARRANTY19.devresersthgirllA.cnI,stcudorPemoHxulortcelE9002Exclusions1. Products with original serial numbers that have bee

2professional the thethe

3--5 (page12)--Quiet Design -- doesthe sound of the compressor startingRmany minutes seconds minutes seconds random to help avoid power surgesR F

Your productthatiss ps the inside air from sideWe recommend always to use a Frigidaire sleeve.CONTROLPANCONDENSATION DRAIN KITELWhen units are shipp

FrigidaireRIGIDAIRERIGIDAIRE GRILLEing(see Frigidaire GE’sC , the actual bafflekit mlook image n5

ATION OF A FRIGIDAIRE PTAC INTO A FRIGIDAIRE WALL SLEEVE8901289101112unit to sleeve6

7LCDITurn off electrical power before service or installation.230V20A230V15A230V30ATable 1—LCDI DETECTION DEVICE323Refer to Table 1 for LCDI detection

the screw13(For Ducted Installations Only)10418415NOTE: Upward air direction should only be used on ducted installations.8

the1041617/Energy Saver: Cooling/Energy Saver: Heating41.2.The dip adjust accordingly in order toallow the wall t control of the unit. When in wall